The ATmega1280 Development Board is a microcontroller board based on the ATmega1280. It has 54 digital input/output pins (of which 14 can be used as PWM outputs), 16 analog inputs, 4 UARTs (hardware serial ports), a 16 MHz crystal oscillator, a USB connection, a power jack, an ICSP header, and a reset button. It contains everything needed to support the microcontroller; simply connect it to a computer with a USB cable or power it with a AC-to-DC adapter or battery to get started.
Micro4you Studio develops ATmega1280 to be board that has structure the same as Arduino Mega called “Arduino Mega ATmega1280” . We provides I/O Pins, including various sizes according to the standard of Board “Arduino Mega”. Moreover, it improves some restrictions better than the standard version of Arduino Mega; so, it is more convenient for user to use.
Features:
-
Use ATMEGA1280 to be MCU on board and run with 16MHz Frequency from Crystal Oscillator
-
128KByte Flash (reserved 4KByte for BootLoader)/8KByte/4KByte EEPROM
-
100% Support C++ Language of Arduino to develop program according to Arduino Mega
-
Use USB Bridge No.FT232RL of FTDI with Over Current Protection to communicate and download Code from computer into board. Moreover, there is Jumper to adjust the operations of Board; it is Program Bootloader into MCU from Port USB inside Board by self without using any external AVRISP Programmer.
-
54 Pin Digital I/O; 14Pin can be programmed to be PWM Function
-
16 Pin Analog Input (ADC 10 BIT 16-Channel)
-
4 UART (Hardware Serial Port) as TTL Logic
-
PCB Board’s size and all positions of Pin Connector are corresponding with Arduino Mega; so, user can install and use it with various Shield Boards that are compatible with Arduino Mega instantly. In this case, the PCB Board’s size is 5.3cm x 10.2cm.
-
Header 10Pin IDE of 8Bit of Digital I/O(D22..D29) for connecting with LCD or Board I/O, it is more convenient to use.
-
Support application of External Supply that is both 7-20V AC and DC. It uses 1A Switching Regulate (LM2575-5V) to reduce heat when using very high current; moreover, it is able to use Power Supply from Port USB, if it uses current not higher than 500mA. In this case, there is circuit to choose source of Power Supply automatically; the Power Supply from USB is turn off automatically if board is connected with external Power Supply.
Documents:
Kit Includes:
-
1 x ATmega1280 Development Board
